How to cut nanoglass?

Cutting nanoglass video
If you use a granite blade to cut the nanoglass directly, and often cause chipping, this will explain to everyone how to reduce this situation.
1: Buy a special nanoglass blade because the hardness of the nanoglass is higher. Natural stone granite and marble, if you use granite blades to cut the nano glass, it is easy to collapse.
2: The newly installed blade must first cut the brick, sharpen the blade and then cut the Nanoglass(Heat and sharpen the blade for at least 15 minutes before starting any cutting.).
3: You should also make sure that you have sufficient and constant cooling water throughout the process. You should also be sure to check if the cutting table is stable as its balance can cause damage to the stone.

4. Be aware of the cutting speed during the process: the regular bed / table speed should be between 2.5 and 4m / min. To cut Nanostone, the first cut should be the length of the plate and the second, in the direction of the plate width.
5. For cuts made in sheets above 18mm we recommend to make the cut in two steps. In the first step, one blade should reach half the plate and in the second step, it should cover another half to finish the cut.
To perform this procedure a plate cannot have any lateral movement. It is imperative that the disc is perfectly aligned with a cut direction.

If you have any questions or buy Nano Glass Panel Cutting Diamond Blade please free contact us. [email protected]

What is nanoglass?

Nano Glass Panel Cutting Diamond Blade

Nano Glass Cutting Diamond Disc
Nano Glass Cutting Blade
Cutting Blade for Nanoglass Stone
Cutting Diamond Disc for Nanoglass Stone
tags: wholesale Nano Glass Cutting Diamond Blade, Nano Glass Cutting Diamond Blade suppliers, Nano Glass Cutting Diamond Blade factory.
Nano Glass Cutting Diamond Blade, Nano Glass Cutting Diamond Blade Suppliers, and Manufacturers at chinamarmoglass.com
As Nano-crystallized glass panel is more and more popular in making a countertop, vanity top, and even wall cladding, this Blade/Disc is a good solution for fabricators to cut this material, without worry of edge-crack, unable to cut, etc.